- Single or multi-bay cabinets
- 3, 4 or 5 tier
- Choice of cooling units
- Fully adjustable, stainless steel racking
- Stainless steel trays – variety of widths
- Stub, full width or a combinations of both rollers
- Suitable for coffin storage
- Multiple finishes available
- Reduced height option
- Wide doors suitable for coffin storage
- End Loading and Pass Through options
Refrigerated End Loading Cabinet Options
LEEC standard pressed trays with raised centre are available in the following width only.
Flat Profile Trays are available in;
- Standard – 560mm Width
- Semi Obese – 660mm Width
- Obese – 750mm Width
The biggest advantage of the LEEC Flat Tray is our ability to Bespoke Tray widths and lengths to the individual customer need. Please contact us with your specific needs.
Full width rollers can be used to accommodate both trays and coffin storage.
Individual doors allow for compartment separation, please note this option limits the cabinet to hold 3 tiers.
Upgrade the entire framework of the cabinet from White plastic coating to Grade T304 Stainless Steel with a Grained and Polished finish so that the cabinet matches the majority of mortuary/embalming room equipment that is stainless steel.
Upgrade the cabinet floor from polyurethane hard wearing GFK (non slip floor) to Grade T304 Stainless Steel with a Grained and Polished finish so that the cabinet floor matches the majority of mortuary/embalming room equipment that is stainless steel.
Audibly alarm is activated when alarm conditions occur.
Obese compartment to accommodate our LEEC’s obsess trays. Also provides a wider door opening to suit wider coffins (used in conjunction with full width rollers).
Available from single to multi door format, width of cabinet dependent on tray size application required. LEEC can provide a three option solution on different height cabinets available, which are all dependent on existing premises. For further information or to arrange a free site consultation with one of our highly trained and vastly experienced sales team please click on the link.
LEEC recommends plinths where possible to elevate the cabinet to stop any potential water ingress protruding into the cabinet and secondly it also increases the spacing between the tiers as the minimum pick up height from a trolley will be lower than if the cabinet is installed directly onto floor level.
Plinths can prove as a cost saving option if floor is not level.
Plinths are available in the following options.
- Wooden plinth finish in a black rubber coving.
- Stainless steel finish.
- Concrete plinth.